LCD Display Replacement
The LCD Display is designed to be easily replaced by the user in the unlikely event that it gets damaged.
Required Equipment
- 3 mm Allen Wrench
- 5 mm Allen Wrench
Recommended Equipment
Procedures
- Loosen the Grips - Use a 3 mm Allen Wrench to loosen the screw on the collar of the handgrip and a 5 mm Allen to loosen the screw at the end of the handgrip (2-3 turns).
![null](https://prismic-io.s3.amazonaws.com/cycleboards/bd9556b4-6a28-4902-9522-5de8e4836322_1.png)
![null](https://images.prismic.io/cycleboards/51fb5742-3fec-416d-95e6-0eb8974b929e_2.png?auto=compress,format)
- Remove the Hand Grip - Twist the handgrip with one hand as you pull it off. If it is too hard to remove, then loosen the end screw 1 revolution at a time until the handgrip can be pulled off.
![null](https://prismic-io.s3.amazonaws.com/cycleboards/b516552e-ede1-441e-8df3-4d17dc43ac42_3.png)
- Remove the Display- Disconnect the old throttle by pulling apart firmly at the connector with 2 hands. Loosen the set screw under the display with a 2 mm Allen enough to slide the display off the handle.
![null](https://prismic-io.s3.amazonaws.com/cycleboards/2570b6e6-0d35-4759-adcd-24a7d5724c49_4.png)
![null](https://prismic-io.s3.amazonaws.com/cycleboards/09f9d3ef-ecf9-4bcb-a383-4d3a08ef814a_5.png)
- Install the Display - Loosen the set screw in the new display enough to slide it onto the hand and plug in the connector.
![null](https://images.prismic.io/cycleboards/16bcb215-1a8f-4135-b077-c23c64fa5abc_6.png?auto=compress,format)
- Install the Hand Grip - When installing the handgrip use a rubber mallet to tap it onto the hand bar to make it easier to install then tighten the 5 mm screw on the handgrip.
![null](https://images.prismic.io/cycleboards/7dbec863-695f-4c2f-9f9e-14f26390ee4a_7.png?auto=compress,format)
![null](https://images.prismic.io/cycleboards/4a605805-edf3-4f93-839b-22eadded1037_8.png?auto=compress,format)
- Tighten the Throttle - Tighten the display in the desired position with a 2 mm Allen and sure that there is ⅛” gap at a minimum between the throttle and the handgrip to prevent the throttle from sticking.
![null](https://images.prismic.io/cycleboards/e2572877-a5b5-42e3-9cb0-8cca836ceb4e_9.png?auto=compress,format)
![null](https://images.prismic.io/cycleboards/12f89f4c-cb34-4951-8690-df4b32d0ef5c_10.png?auto=compress,format)
The gap between the throttle and the handgrip ensures that the throttle does not rub which could potentially cause the throttle to stick.
Have more questions? Contact support@cycleboard.com